The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.







Device based on Ethernet chip Wiznet W5500 (datasheet) that allows you to connect an Arduino board (One or Mega) to a LAN using the Ethernet library. It has connector micro SD card, connectors for inserting the PoE module (not included), two connectors for digital outputs (D5 and D6), two connectors for analog inputs (A2 and A3), two connectors for I2C signals (TWI ), reset button, status lights, and supports up to eight simultaneous socket connections. Arduino communicates with both the W5500 and SD card using the SPI bus (through the ICSP connector). These are the digital pins 10, 11, 12 and 13 Arduino One and 50, 51 and 52 for Arduino Mega. On both boards, pin 10 is used to select the W5500 and pin 4 for the SD card. These pins can not be used as I / O. Arduino Mega pin 53 (SS), is not used to select the W5500 and SD card, but must be set as an output or the SPI interface will not work. Note: this shield is not currently compatible with Arduino Pro Zero Board. Dimensions (mm): 68,3x53,10
Documentation and useful links​

 

Write a review

Please login or register to review

Arduino Ethernet Shield 2


Discontinued product

Tags: arduino ethernet shield 2, 7300-ethernetshield2, open store

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.