The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.







Discount available! Recommend Humidity and temperature sensor to your friends and get your Discount.

The DHT22 is a basic, low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air, and spits out a digital signal on the data pin (no analog input pins needed). Its fairly simple to use, but requires careful timing to grab data. The only real downside of this sensor is you can only get new data from it once every 2 seconds, so when using our library, sensor readings can be up to 2 seconds old. Simply connect the first pin on the left to 3-5V power, the second pin to your data input pin and the right most pin to ground. Although it uses a single-wire to send data it is not Dallas One Wire compatible! If you want multiple sensors, each one must have its own data pin! We have written an Arduino library with example code Compared to the DHT11, this sensor is more precise, more accurate and works in a bigger range of temperature/humidity, but its larger and more expensive Comes with a 4.7K - 10K resistor, which you will want to use as a pullup from the data pin to VCC.  

Features
  • Low cost
  • 3 to 5V power and I/O
  • 2.5mA max current use during conversion (while requesting data)
  • Good for 0-100% humidity readings with 2-5% accuracy
  • Good for -40 to 80°C temperature readings ±0.5°C accuracy
  • No more than 0.5 Hz sampling rate (once every 2 seconds)
  • Body size 15.1mm x 25mm x 7.7mm
  • 4 pins with 0.1" spacing
  • Weight: 2.4 g
Download

Write a review

Please login or register to review

Humidity and temperature sensor

  • Price: 5.90€


Tags: humidity temperature sensor

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.