Small Breakout board with the ultraviolet light sensor ML8511. This sensor works by outputing an analog signal in relation to the amount of UV light that's tested (mW / cm²). The range of the most effective light tested by the sensor is 280-390nm. ML8511 UV light can be used with an analog voltage output proportional to the amount, connected directly to AD converter of MCU.

Suitable for ultraviolet testers, ultraviolet detectors for outdoor use, ultraviolet detectors for germicidal lamps….

• Supply:

       - 5 VDC via the GND and VIN pins
       - 3.3 VDC via GND and 3V3 pins

• Current consumption: about 2 mA
• Range: 280 to 390 nm (UV-A and UV-B)
• Maximum output current (OUT): up to 5 mA
• Operating temperature: from -20 ° C to + 70 ° C
• Dimensions (mm): 13.5x11.65x3
• Weight: 2 grams

PINOUT
- OUT: output voltage directly proportional to the intensity of the ultraviolet radiation
- VIN: 5 VDC power supply
- GND: ground
- 3V3: 3.3 VDC power supply
- EN: Enable, when the logic level is "0", the module no longer detects UV radiation

• Datasheet ML8511
• Library