Breakout SIM900 GSM Module
10 or more 37.80€
50 or more 33.60€
100 or more 31.50€
This breakout board measuring about 1.75×1.95 inches, has two pin strips (a 3-pin one and a 16-pin one) used to connect with the circuit board of the remote control device; the first pin strip carries digital power (both positive and negative), in addition to the ignition control line (PWR), while the second strip contains all the communication signals and lines to and from the GSM module, as well as the analogical section of the phones (AGND, contact 11).
The module is provided assembled and tested.
Write a review
Your Name:Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below:
If you’re not a geek, and reading over this stuff freaks you out, have no fear! We’re building Pinoccio to be friendly and easy ...
Using the GSM/GPRS & GPS Shield: call examples Thu, 23 May 2013 02:59:30 -0700A few months ago, we presented a powerful shield that can enable devices from the Arduino family (Uno and Mega) to interface ...
Isn’t it time for Fair Trade Electronics? Tue, 21 May 2013 03:13:24 -0700Perhaps because of resources crisis that we live, finally, a growing awareness about the materials is rising. In my opinion, ...
The Smart Citizen Kit: Crowdsourced Environmental Monitoring (on Kickstarter) Tue, 21 May 2013 02:55:06 -0700We are not asking you to eliminate your carbon footprint, nor attempting to turn you into a climate change crusader, nor ...
Autodesk acquires Tinkercad Mon, 20 May 2013 09:51:36 -0700In case you lost it, Autodesk announced they’ve signed a deal to acquire Tinkercad and revive the popular web-based 3D design ...










